Radio Freq Amplifier Printed Circuit Board

Round Picnic Table

SHEET METAL ELBOW DUCTWORK

Patio Base Drawing

Rons Deck Drawing

My Entertainment Center

Sony WEGA

Sandy's Kitchen

Eastern View of Chateaux Royal & Rod

Northern View

Cut away View

Southern View

Western View on cloudy day

This RF Module was designed in Orcad Layout for RF Micro Devices RF2125P for use in portable battery powered devices. The output power is 1Watt.

The seats and table height are adjustable. The mechanical functioning of the table was worked out in real time useing Autodesk Inventor.

AUTODESK INVENTOR SHEETMETAL EXAMPLE. NOT ALL FEATURES COULD BE CREATED WITHIN THE SHEET METAL PROGRAM MODULE . A PROFILE FOR THE CURVED EDGES HAD TO BE DONE ON THE MODELING SIDE OF INVENTOR. WHAT A SHAME ON AUTODESK!

To kick off this page, my pal Ron wants to build a patio area to replace the awning shown here. As one of many similar brick A-frames on his street, the choices in design are limited. Here we have the opportunity to model different ideas before deciding on a remedy. This project and others will highlight the cool side of CAD in finding solutions to interesting problems in or outside the work place. House was built using AutoCad 2002.

Here is my solution though not the only one. Ron would like to wood frame the entire porch area. It will be shown if he decides to go in that direction. The Sunsetter Awning is retractable with a remote control and was made in AutoCad then Xref'd into Mechanical Desktop where the deck was built.

This next design solved a problem with keeping the BOSE 901 series speakers in a surround sound system. The cabinet sides of standard entertainment center will cancel the reflected rear facing drivers, causing a muffled sounding presentation. The cantilevered sides shown here, allow the sonic waves to continue out into the room.

Here is a photo with a Sony Wega TV inside. Unit is holding around 600lbs. of equipment. Nice Stuff!

Sandy is remodeling her kitchen area, deciding on an Italian motif. Drawings generated from the model will be used to fabricate some of the fixtures. The walls were generated in AutoCad while the nook and shelves were done with Mechanical Desktop 6.0

The customer is looking for a retirement residence on a steep hillside. Also the lower level is for car restorations, sheetmetal & woodshop. This model will be presented to the Elizabeth Township Board for approval along with the plan drawings generated from Autodesk Revit software.

Proposed deck on rear elevation of structure. Also notice the french doors on the master bedroom.

Floorplan of residence area

The spiral staircase entrance provides a safer main entrance.

Showing the two garage doors behind wich are there respective shops.